Dimensioning Guide for Slots
This Tip shows how to dimension slots. The key is that dimensioning a slot is really no different from dimensioning a hole. As the drawing shows, to use positional control, you must define a boundary. The other factor shown on the drawing is that how you dimension a slot depends on how the slot is to be produced: punched, machined, etc.
This Tip is available as an Adobe PDF file. In order to view it, you must have installed Adobe Acrobat or the free Adobe Acrobat Reader. To download the free reader, click the "Acrobat Reader" icon.
Launch Tip in Adobe Acrobat
|Copyright © 2018 Genium Group, Inc. All Rights Reserved.|
|All materials contained on this site are protected by United States copyright law and may not be reproduced, distributed, transmitted, displayed, published or broadcast without the prior written permission of Genium Group, Inc. You may not alter or remove any trademark, copyright or other notice from copies of the content. However, you may download material from The Drafting ZONE on the Web (one machine readable copy and one print copy per page) for your personal, noncommercial use only.|